Structural design

Design of isolated or spread footing: Spread footing is basically a pad used to spread out loads from columns over...

Selection of foundation types: Foundation have to transmit the load of the structure on to the sufficient area of the...

 Shear wall It is the vertical structural element of a reinforced concrete framed structure which is provided to resist in-plane...

Column Column is the vertical compression member of the building with or without bending moment. In normal residential and commercial...

Short Column: When the slenderness ratio, lex/d and ley/b both, of the column is less than 12 then that column...

Column Column is the vertical structural member which is subjected to compressive forces with or without bending moment. The inclined...

Design of Secondary Beam: The structural member which is primarily subjected to flexure or bending are known as beam. Beam...

Design of primary beam: Beam is the structural member which is primarily subjected to flexural moment or shear stresses ....

Beam Design The design of beam is presented below steps wise: [ hope you have read details before, if not...

Two way slab design Two way slabs are those slab which are supported on unyielding supports on all four sides...